The power supply could be bad, a connection could be loose, the circuit design might be faulty, or something could have been damaged due to pests or water. Multiple things can go wrong that will prevent LED bulbs from working properly in the car. Run LED Lights From a 12v Battery FAQ Why don't LED bulbs work in my car? ![]() Correcting these problems is a simple task, and if the home lighting system is wired correctly, there should be no problems in using it for the foreseeable future. Problems may include a blown fuse or damaged LED (easily done during wiring), or a loose connection somewhere between the lights and the battery. The anode should be wired into the on/off switch, which is then wired into the positive port of the battery.Īt this point, it is a good idea to check that the home lighting system works. The cathode goes into the ground-it can be soldered directly to the negative port of the 12v battery. When you are sure which lead goes to which, it is time to solder the wires to the 12v battery. When it is lit, the black test lead will be attached to the cathode, and the red test lead will be attached to the anode. Once the LEDs are in position, examine them and find the leads the negative lead (or cathode), can be identified in one, or more than one, of these ways: it is the shorter lead, it is a flattened section on a round LED, or inside the LED, each lead is attached to a triangle-shaped node the positive lead (or anode) is attached to a larger node.Ī diode test function meter will light up the LED when correctly applied. This can be done by checking the current with a voltmeter, or by wiring both items to a lamp or device which is known to work. This is the length of wire necessary to connect the LEDs to the power supply.īatteries and switches should be checked for faults before being wired to the LED home lighting system. ![]() Locate a nearby place to put the battery and on/off switch then, measure the distance between where the lights are and where these will be. Leaving a battery to dangle will eventually cause connections to break. ![]() Unless you are installing these near an existing 12v battery supply, prepare to build a ledge, box, or other support. Batteries operating lights on a high wall, for example, will need to have something supporting their weight. The first thing that needs to be done when connecting LEDs to a battery is to consider where they will go.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |